CCNA BASIC INTERVIEW QUESTIONS AND ANSWERS PDF DOWNLOAD

Pages: 230
File size: 3.97MB
License: Free PDF
Added: Kazira
Downloads: 43.670

Rollover cable — To connect Console port to Computer. Protocols determine how data are transmitted between computing devices and over networks. Anonymous November 14, at It’s worthy of reading materials appreciate it expect for more tips and guides.

Its job is very simple — anything that comes in one port is sent out to the others. Router is a device that forwards data packets along networks. Anonymous April 26, at 4: On a router or switch you would use the command traceroute and on a pc you would use tracert. RAM is very fast memory that loses its information when the router is shutdown or restarted.

Frequently Asked Ccna Interview Questions And Answers Pdf

What does the “show protocol” display? A broadcast domain is a logical division of a computer network, in which all nodes can reach each other by broadcast at the data link layer. Anonymous August 1, at 6: Both Tracert and traceroute commands do similar purpose.

Segments converted into Packets or Datagrams and Network Header is added. Anonymous December 6, at Alphanumeric input from user converted into Data.

Download Free CCNA Job Interview Questions Answers PDF

Yes i know already in before because my ccna has been completed in Anonymous December 9, at 4: To connect one comp to switch OR one switch to router use straight cable. Unknown November 4, at 1: On social networking if you are sharing stuff of this site or documents then you have to credit back to us with sharing our link. Why you use ping? Differentiate full-duplex from half-duplex? You are not allowed to upload these documents at other websites except social networking sites.

User EXEC mode only has limited options. Anonymous December 16, at 1: Newer Post Older Post Home. Class B range from Simply in p2p, network devices act as both client and server.

While using this site, you agree to have read and accepted our terms of usecookie and privacy policy. Nice work, most of the basic questions is covered.

Basic CCNA Interview Questions AND Answers

Anonymous June 15, at Hub has single collision domain and single broadcast domain. Round-trip time RTTalso called round-trip delay, is the time required for a packet to travel from a specific source to a specific destination and back again. What is the difference between tracert and traceroute.

Agyapong Nkrumah Junior August 11, at 2: After completion of below form downloading status will be change automatically after few seconds so don’t go away or close this page until you got the message of successful completion of your request.

Anonymous August 22, at amd Actually ipv6 is bit. Let’s look in detail. What are the differences between static ip addressing snswers dynamic ip addressing? What is Round Trip Time? A peer-to-peer P2P network is a type of decentralized and distributed network architecture in which individual nodes in the network called “peers” act as both suppliers and consumers of resources. Disclaimer Interview Questions Answers.

To connect different group device use Straight Cable.

Source is the computer sending the packet and the destination is a remote computer or system that receives the packet and retransmits it.

Switches have multiple collision domains and have a single broadcast domain. Here are the five passwords you can set on a Cisco router: Explain different cable types?

Define and explain the five conversion steps of data encapsulation. Aptron December 29, at 6: Hubs, switches, and routers are all computer networking devices with varying capabilities. Routing is usually performed by a dedicated device called a router. But give all the information about ccna. Networking Sub Category Is: Explain difference between Router, Switch and Hub?